Filter
Top Products
Overheating protection
The overheating protection device is
located on the right-hand side of the
appliance underneath the On/Off
button. This switches the heating off
automatically if the temperature in the
steam generator gets too high. F27 will
appear in the programme/temperature
display and the cooling down phase
will begin.
The cooling down phase will be
completed in approx. 1 minute and
several beeps will sound. F27 will flash
in the programme/temperature display
for a short while and then three
horizontal bars ---will appear. After a
while F20 will appear in the display.
Proceed as follows:
^ Switch the appliance off and open
the door.
^ Allow the appliance to cool down for
approx. 30 minutes.
F20 will disappear from the display
during this time.
^
Remove the overheating protection
device cover cap (see arrow). Use a
screwdriver or similar to press the
button underneath in again.
^
Replace the cover cap.
The steam oven can now be used
again in the normal way.
If the overheating protection device
trips again, contact the Service
department.
Safety features
40