Miele DG 4164 L Oven User Manual


 
Installation work and repairs to
electrical components of this
appliance must only be carried out
by a suitably qualified and
competent person in strict
accordance with current local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
What to do if, ...
... the appliance beeps after the start
of a programme, and the word "door"
appears in the time display.
The door has not been closed properly.
... the mains fuse has tripped.
Reset the trip switch in the mains fuse
box, and switch the appliance back on.
If it still cannot be operated, contact a
qualified electrician or the Miele Service
Department.
... the appliance does not heat up.
Check whether the Demonstation mode
has been set (see "Programming").
... the appliance is locked during a
prolonged power cut and you want to
remove the food from it.
Caution: the appliance will still be hot
and under pressure.
Pull out the shelf. Then using the thumb
of your right hand, push the door
release forwards slowly a little bit at a
time.
Caution! Steam will escape from above
and below the door hinge.
Open the door very carefully. Danger of
scalding with hot steam.
... steam suddenly escapes from the
appliance door.
Check whether
the safety valve has tripped. Proceed
as described in "Pressure release /
Safety valve".
the pressure release has tripped.
Proceed as described in "Pressure
release / Safety valve".
the rubber door seal is not fitting
correctly or is damaged, e.g. cracks
are visible. Fit the seal correctly or, if
necessary, replace it.
Problem solving guide
52