Filter
Top Products
Attaching the connecting panel will
align the appliances in depth.
If one of the appliances protrudes
further forward than the other, start with
the further forward appliance:
^ Place the connecting panel g so that
the vertical slots are on the side of
the panel which will be be attached
to an appliance first. Attach it loosely
with two screws.
^ Push connecting panel g until the
central stay on the bracket touches
the side of the appliance.
^
Now tighten both screws h.
^
Secure connecting panel g to the
other appliance. To do this push the
appliances together a little, as
necessary.
Installation steps at the back of the
appliances
^
Fit connecting bracket i onto the
top of the sides in the middle.
^ Fit connecting piece j into the
relevant gap below.
^ Tighten connecting piece j using
screw k supplied.
Warning: Do not drill a hole in the
appliance for this screw.
To avoid vibrations, the connecting
bracket, connecting piece and
screw must not touch the pipework
at the back of the appliances.
Installing in a side-by-side combination
38