Filter
Top Products
Refitting the handle
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws b.
Mounting plate c must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^
tighten both grub screws a with a
suitable allen key until mounting plate
c lines up correctly.
^
Then tighten all 4 screws b.
^
Slide the side section of the handle
d into the guides on the mounting
plate until it clicks into place.
It is important to check that the side
section of the handle d does not
come into contact with the door seal
when opening the door, as this
would damage the door seal
permanently.
If, after you have refitted the handle,
you find that the side section does
touch the door seal when the door is
opened:
^
Realign mounting plate c with grub
screws a until the mounting plate
and the side section of handle d are
at the correct angle and the side
section does not touch the door seal
when the door is opened.
Changing the door hinging
45