Filter
Top Products
. . . the alarm sounds and the alarm
off sensor flashes.
The temperature in the freezer is too
warm, because
^
the door has been opened too
frequently, or large amounts of fresh
food have been put in at once for
freezing.
^
the ventilation gaps are blocked.
^
there has been a lengthy interruption
to the power supply.
Once the problem has been resolved
and the temperature has reached the
correct level again, the alarm sensor
will go out and the alarm will stop.
...abarislituporflashing in the
temperature display.
Check the temperature display about
6 hours after switching on the
appliance. Only temperatures within the
range the appliance can display will be
shown.
..."_F" shows in the temperature
display.
There is a fault. Call the Service
Department.
..."dn" appears in the temperature
display.
The demonstration function is activated.
^
Call the Service Department.
..."nA" appears in the temperature
display.
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^
Touch the alarm off sensor whilst "nA"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
appliance during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost, check
that it is still safe to use and if so use it
as soon as possible. Defrosted food
may only be re-frozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
current temperature in the freezer will
then show in the display again.
. . . you cannot switch the appliance
off.
The safety lock has been activated.
Problem solving guide
32