Filter
Top Products
. . . food has frozen together.
Use a blunt instrument, e.g. a spoon
handle or plastic scraper, to prise it
apart carefully.
. . . the alarm sounds and the
temperature display flashes.
^
Has the appliance door been open
for longer than 60 seconds?
If this is not the case, then the freezer
temperature has risen above the
temperature set because
^
the door has been opened too
frequently, or large amounts of fresh
food have been put in at once for
freezing.
^ the ventilation gaps are blocked.
^ there has been a lengthy interruption
to the power supply.
Once the problem has been resolved
the temperature display will light up
constantly and the alarm will stop.
...abarislituporflashing in the
temperature display.
Check the temperature display about 6
hours after switching on the appliance.
Only temperatures within the range the
appliance can display will be shown.
. . . "F0" to "F9" show in the
temperature display.
There is a fault. Call the Service
Department.
..."nA" appears in the temperature
display.
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^
Press the alarm off button whilst "nA"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
appliance during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost, check
that it is still safe to use and if so use it
as soon as possible. Defrosted food
may only be re-frozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
actual current temperature in the
freezer will then show in the display
again.
At the end of a power cut, the
appliance will start operating again at
the last temperature setting selected.
. . . the Super freeze indicator light
does not light up, even though the
appliance is working.
The indicator light is defective. Call the
Service Department.
. . . you cannot switch the appliance
off.
The safety lock has been activated.
Problem solving guide
28