Filter
Top Products
Preparing the appliance
^ Slide cover strip a into the holder in
the middle of the appliance as
illustrated with the bumps facing
downwards. The bumps will fit into
the keyhole slots.
^ Position the mains electricity cable so
that the appliance can be connected
easily once installed.
^
Push the appliance two-thirds of the
way into its niche.
When doing this, make sure that the
mains cable does not get trapped.
^
With 16 mm thick furniture walls:
clip spacers b over the hinges.
^
Open the appliance door.
^ Using a screwdriver, remove cover
c from the top corner of the
appliance.
^
Fit cover d onto fixing bracket e.
^
Secure fixing bracket e to the top of
the appliance with screws f
(M5 x 15).
Building in the appliance
41