Filter
Top Products
Remove the catalytic back panel,
roof liner and side liners (if fitted)
before using oven sprays. The
chemicals used in oven sprays will
damage catalytic enamel rendering
it ineffective.
Apply a spray oven cleaner to the
soiled areas. Leave to take effect for a
couple of minutes only!
If necessary use a soft sponge, soft
nylon brush or a scraper suitable for
glass surfaces to loosen the soiling.
Repeat the process if necessary.
After cleaning rinse thoroughly with
clean water and then dry thoroughly.
Important
For optimum performance of the
PerfectClean enamel it is important to
clean the oven and accessories after
each use.
The surfaces will become harder to
clean and the anti-stick properties
will deteriorate if soiling is not
removed after each use and allowed
to build-up. In extreme cases
cleaning may even become
impossible.
The following cause lasting damage
to the surface structure and reduce
the anti-stick effect and must not be
used on PerfectClean surfaces:
– abrasive cleaning agents
– wire wool or metal scourers
– pot scourers
– oven cleaning pads
– sponges and cloths which have
previously been used with
abrasive cleaning agents.
– oven spray must not be used in
a hot oven or left on for too long.
– items coated with PerfectClean
enamelling must not be cleaned
in a dishwasher.
Note
Soiling such as spilt juices and cake
mixtures are best removed whilst the
oven or tray is still warm. Exercise
caution, make sure the oven is not hot -
danger of burning!
Spilt fruit juices may cause lasting
discolouration of the surfaces and
roasting can cause matt areas to
appear. Clean these following the
instructions given above and do not try
and use force to remove them! This
discolouration is permanent but will not
affect the efficiency of the enamel.
When baking items with a high salt
content (e.g. continental pretzels) place
them on baking parchment in the
baking tray or grill pan. Sodium
deposits can cause lasting
discolouration to PerfectClean
surfaces.
Cleaning and care
42