Filter
Top Products
. . . no noise is heard when the oven
door is opened during operation.
This is not a fault.
If the door is opened during operation,
the door contact switch causes the
oven heating, and the fan if on "Fan"
setting, to be switched off.
...a noise can be heard after baking,
roasting or grilling.
This is not a fault.
The cooling fan continues to run for a
while after the oven has switched off to
prevent any humidity building up in the
oven, on the control panel or in the
oven housing unit. When the
temperature has fallen sufficiently the
fan switches off automatically.
The temperature will fall faster when the
oven door is opened partially or fully.
. . . cakes and biscuits are not cooked
after following the times given in the
chart.
Check whether,
^ the correct temperature was set.
^ there has been a change to the
recipe. The addition of more liquid or
more eggs makes a moister mix
which would need longer to cook.
^ the roasting filter had been left in
place in front of the fan when cooking
with "Fan D" heat, or was in place for
"Auto roast E". In this case baking
times might be lengthened by 10 to
15 minutes.
. . . cakes or biscuits are unevenly
browned.
There will always be a slight
unevenness.
If the item being baked is browning
very unevenly, check when baking with:
Fan Heat D:
– whether the temperature was set too
high,
– whether the roasting filter was in place,
– whether the correct runner height
was used.
Conventional A:
– the colour and composition of the
baking tins being used. Light
coloured, shiny, or thin walled tins
are less suitable,
– whether the correct runner height
was used.
. . . spots like rust appear on catalytic
surfaces.
When roasting on the rack, the
circulating air sometimes picks up
spices, which are then deposited on
the oven interior walls. Such residues
are not removed by catalytic cleaning,
they are best removed while fresh with
a mild washing up liquid solution and a
soft brush.
. . . the timer display does not light up
when the oven is operating.
This is not a fault. The display does not
light up if the time of day display has
been switched off.
Press buttons "f" and ")" at the
same time. "12:00" will appear in the
display.
. . . the time cannot be re-set after a
power failure.
This is not a fault. Check whether the
function selector is still set to one of the
functions. If it is then turn it to the "0"
position. The time of day can now be
set.
Problem solving guide
49