Filter
Top Products
Replace the halogen lamp:
12 V, 20 W,
heat resistant up to 300°C, G4
socket, Osram, Type 64428.
Exercise caution when changing a light
bulb. Halogen lights get very hot during
use and will remain hot for some time
after being switched off.
Do not touch the surface directly when
changing the bulb as grease particles
from your fingers will adhere to the sur-
face and damage it. Please follow the
manufacturer’s instructions.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
. . . no noise is heard when the oven
door is opened during operation.
This is not a fault.
If the door is opened during operation,
the door contact switch causes the
oven heating, and the fan if on "Fan"
setting, to be switched off.
. . . a noise can be heard after bak-
ing, roasting or grilling.
This is not a fault.
The cooling fan continues to run for a
short time after the oven has been
switched off to prevent any humidity
building up in the oven, on the control
panel or in the oven housing unit. When
the temperature has fallen sufficiently
the fan switches off automatically.
The temperature will fall faster when
the oven door is opened partially or
fully.
. . . cakes and biscuits are not
cooked after following the times
given in the chart.
Check whether,
the correct temperature was set.
there has been a change to the
recipe. The addition of more liquid or
more eggs makes a moister mix
which would need longer to cook.
the roasting filter had been left in
place in front of the fan when cook-
ing with "Fan heat D" or "Intensive
Bake F" or was in place for "Auto
Roast E". In this case baking times
might be lengthened by 10 to 15
minutes.
. . . cakes or biscuits are unevenly
browned.
There will always be a slight uneven-
ness. Product information sheets give a
percentage result for standard brown-
ing tests. These refer to results for one
tray.
If the item being baked is browning
very unevenly, check:
– when baking with "Fan Heat D":
whether the temperature was set too
high,
whether the roasting filter was in
place,
whether the correct runner height
was used.
Correcting minor faults
67