Filter
Top Products
The appliance is supplied right-hand
hinged. If left-hand door hinging is
required, follow the instructions below.
You will need the following tools:
–
A Torx
®
15 and a Torx
®
25
screwdriver,
–
a flat-bladed screwdriver,
–
a spanner (supplied).
Two people are needed for
changing the door hinging.
Removing the door handle
^
Pull door handle a towards you. Side
section b slides back.
^
Pull side section b firmly back out of
the guides on the mounting plate.
^
Undo the 4 screws (Torx
®
15) in the
mounting plate, and remove the
handle.
^
Remove the cover caps from the
opposite side, and fit them into the
empty holes.
The hinge parts (hinge plate and
hinge pin) must be screwed
sufficiently tightly as otherwise the
appliance door could fall off. Danger
of injury. Also the door may not
close fully, which would prevent the
appliance from cooling down
properly. Take care to secure the
hinge plate and pin tightly. Check
all screws and tighten them if
necessary.
Changing over the door
Caution. The door is not secure as
soon as the hinge pin is removed.
^ With the help of another person, tip
the appliance back slightly.
^
Unscrew retaining screw c on
bottom right hinge plate d.
Changing the door hinging
38