Filter
Top Products
^
Take the door and guide the upper
door bearing bush onto upper hinge
pin k.
^
Pivot the door and place hinge pin e
into hinge plate d. Important. Turn
the hinge pin if necessary, so that the
tab is pointing to the inside of the
door and the notch to the outside.
The hinge pin will then click into
place.
^ With the help of another person,
carefully tip the appliance back and
tighten retaining screw c. Tighten it
using a suitable spanner.
^
Align the door with the appliance
housing again if necessary using the
long slots in the lower hinge plate.
Then tighten the screws.
^
Replace spacer pin p underneath
the right-hand side of the door.
Refitting the handle
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws b.
Mounting plate c must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^
tighten both grub screws a with a
suitable allen key until mounting plate
c lines up correctly.
^
Then tighten all 4 screws b.
^
Slide the side section of handle d
into the guides on the mounting plate
until it clicks into place.
Changing the door hinging
41