Filter
Top Products
Before using for the first time
Protective foil
The stainless steel trim to the interior
shelves and the door shelves has a
layer of protective foil to prevent
damage during transportation.
On stainless steel appliances, the outer
surfaces are also covered with
protective foil.
^
Do not remove the foil until the
appliance has been positioned in its
final location.
Cleaning and care
^ Treat the stainless steel trim to the
interior shelves and the door shelves
with the Miele stainless steel
conditioner supplied as soon as you
have removed the foil.
^ On stainless steel appliances also
treat the side panels with the Miele
stainless steel conditioning agent
supplied as soon as you have
removed the protective foil.
The appliance doors have a special
finish which is resistant to soiling. Do
not use Miele stainless steel
conditioner on the appliance door.
Important. Each time it is used, the
Miele stainless steel conditioning
agent forms a water and dirt repellent
protective coating.
^
Clean the inside of the appliance and
the accessories with lukewarm water
and a little washing up liquid, and then
dry with a soft cloth.
Active charcoal filters
(Active Air Clean charcoal filters)
^
Place the active charcoal filters
supplied in the holder, and place the
holder on one of the refrigerator
shelves (see "Active charcoal filters").
Operating the appliance
A light touch of the finger on the
sensors is all that is required to operate
this appliance.
Switching on
The refrigerator section/PefectFresh
zone and freezer section are switched
on together with the On/Off sensor.
^ Touch the On/Off sensor until the
temperature display lights up.
The temperature display for the
refrigerator section will show the current
temperature in the refrigerator section.
If the temperature in the freezer section
is above 0 °C, only bars will light up in
the temperature display for the freezer
section. As soon as the temperature is
below 0 °C, the temperature display for
the freezer section will show the current
temperature in the freezer section.
The "Freezer" symbol and the Alarm off
sensor will flash until the temperature in
the freezer section has cooled down to
the correct temperature for freezing.
Switching on and off
18