Filter
Top Products
..."nA" appears in the temperature
display.
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^
Touch the alarm off sensor whilst "nA"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
freezer section during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer section.
If it has defrosted or started to defrost,
check that it is still safe to use and if so
use it as soon as possible. Defrosted
food may only be re-frozen after it has
been cooked.
The warmest temperature will show in
the display for about 1 minute. The
display will then revert to showing the
current temperature in the freezer
section.
. . . you cannot switch the appliance
off.
The safety lock has been activated.
. . . the interior lighting in the
refrigerator is not working.
^
Was the refrigerator door left open for
too long? The lighting switches itself
off automatically after approx. 15
minutes if the door is left open.
If this is not the case, then the interior
lighting is defective.
^
Call Miele Service.
The LED lighting may only be repaired
or replaced by a service technician.
There are live electrical components
under the cover. Danger of injury and
damage to the appliance.
Do not remove the cover. If the
cover is damaged or needs to be
removed due to damage, exercise
caution. There are lasers in the
lighting (laser beam class 1M) which
you should avoid looking at directly.
Do not use optical instruments
(magnifying glass or similar) to look
at the lighting either.
. . . the floor of the refrigerator
section is wet.
The condensate drain hole is blocked.
^ Clean the condensate channel and
drain hole.
If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent unnecessary loss of
temperature it is advisable not to
open the doors while waiting for the
appliance to be serviced.
Problem solving guide
53