Filter
Top Products
Cut out
^
Make the countertop cut-out following
the dimensions given in the
illustration.
Remember to maintain a minimum
distance of 2" (50 mm) between the
rear wall and the right or left side.
See also the "IMPORTANT SAFETY
INSTRUCTIONS".
^
Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
If during installation the seal around
the frame does not sit flush with the
countertop in the corners, the corner
radius, maximum
3
/
16
" (4 mm), can
be carefully filed down to fit.
This cooktop has a seal underneath
to keep it securely in position.
Spring clips are not required. Any
gap between the frame and the
countertop will reduce as the
cooktop is used.
Installing the cooktop
^
Feed the cooktop connection cable
down through the cut-out.
^
Place the cooktop centrally in the
cut-out. When doing so make sure
that the seal under the cooktop sits
flush with the countertop on all sides.
This is important to ensure an
effective seal. Do not use sealant.
^
Connect the cooktop to the main
power supply.
^
Turn the cooktop on and check the
function.
Installation
47