Filter
Top Products
Installation
The appliance must be built in
before it can be used. Otherwise it
poses an electric shock hazard.
There are three spacers in the
accessory pack: one for the right-hand
side (R) and two for the left-hand side
(L), depending on whether the housing
unit wall is 16 or 19 mm thick.
^ Attach the correct left-hand spacer
applicable to the thickness of the
housing unit wall to one of the hooks
supplied.
^
Attach the other hook to the
right-hand spacer.
^
Before securing the hooks, make
sure that the screws are fitted where
the housing unit wall is at least 16
mm thick.
1. Niche height 350 mm
^
Draw a line on both sides of the
housing unit 337 mm above the floor
of the housing unit.
^ Position the lower edge of the spacer
on this line and align the stopper at
the front of the spacer with the front
of the housing unit side wall.
^ To secure the spacers and hooks,
place a screw in one of the front two
holes and another in the middle of
the long hole at the back.
The long hole allows for adjustment if
necessary, and the two additional
holes are in case additional screws
are required.
Installation
60