Filter
Top Products
^
Slide the appliance into the housing
unit, and pull the cable with the plug*
through the back of the unit.
^
Secure the appliance at the front by
lifting it over the hooks and lowering it
into position.
^
Check that the appliance is secure
by pushing lightly on the upper edge
of the front frame.
^
Check that it is correctly aligned.
^
Connect the appliance to the
electricity supply.
* Plug shown is for illustration purposes
only
2. Niche height 360 mm
^
Remove all the accessories,
including the turntable and the roller
ring, from the microwave oven cavity.
^
Place the microwave on its right-hand
side so that the front frame
overhangs the front of the table or
work surface.
^
Unscrew the three feet under the
microwave, and replace them with
the three larger feet using the same
screws.
^
Screw the spacer disk from the
accessory pack into the hole on the
underside of the appliance where the
cable is attached, using the short
screw supplied.
^ Draw a line on both sides of the
housing unit 347 mm above the floor
of the housing unit.
^ Now proceed as described in "1.
Niche height 350 mm".
Installation
61