Filter
Top Products
Installation
6
Reversing the Oven Door
NOTE: This operation should only be carried out by a
suitably competent person.
Remove the Oven Door Inner Glass.
1. Open the oven door and
open the door inner glass.
2. Remove the screw securing
the inner glass retaining clip
and remove the clip.
3. Lift up the inner glass and
remove, ensuring that the
pivot spacer is removed
from the lower inner glass
pivot and retained.
4. Remove the black plastic
plugs from the top and
bottom of the door and fit
to the holes where the
inner glass pivots were
removed from.
Remove the Oven Door.
5. Remove the door roller catch and blanking plate from
the inside of the door and swap these over.
6. Whilst supporting the door,
unscrew and remove the top
door pivot bolt from the top
door hinge assembly.
7. Remove the door and lay on
a flat surface or workbench.
8. Unscrew the screws securing
the door handle and remove
the door handle.
9. Remove the top door hinge
and fit to the bottom
opposite corner of the door.
10. Remove the bottom door
hinge and fit to the top
opposite corner of the door.
Fit Blanking Plugs.
Remove Top
Door Pivot Bolt.
Remove Top Door Hinge
Remove Handle
Securing Screws
Swap Roller Catch and
Blanking Plate over.
11. Remove the inner glass
latching studs and fit to
opposite side of door using
Loctite 243 to secure.
12. Turn the door handle over
and fit to the other end of
the door where the hinges
were removed from. Ensure
Flat of handle is to the
outside.
Remove the Upper and Lower Door Hinges and Door
Catch.
13. Remove the bottom door
pivot bolt and spacers and fit
the pivot bolt to the top door
hinge assembly (as this will
be swapped over and fitted
to the bottom of the other
side of the oven).
14. Remove the 4 blanking
screws from the front of the
oven.
15. Remove the Hinge Plate from
the top of the oven and fit
diagonally opposite, to the
lower corner.
16. Remove the Hinge Plate from
the bottom of the oven and
fit diagonally opposite, to the
upper corner.
17. Fit the screws removed at
Item 14 above to where the
hinges were fitted.
Remove these screws to remove
top and bottom hinges.
Bottom Door Pivot
Bolt and Spacers.
Remove screws top and bottom
and fit to where hinges removed
from.
Remove Latching Studs
Remove Screw and
Retaining Clip.