Filter
Top Products
8
13. Remove the junction box cover and identify the large terminal block located in the
top left corner of the box. See the illustration below.
14. Refer to the illustration on the next page for the wiring diagram of the terminal block.
Located the wires marked 16 and 17 on the terminal block and reverse them.
Remove the existing wire labels and change wire 16 to 17 and 17 to 16.
Replace the junction box cover and the machine front panel.
15. The conversion is complete.
MD-44 Direction Field Conversion (continued)
MD-44 Direction Field Conversion
13
WARNING:
Electrocution or serious injury may result when working on an
energized circuit.
Disconnect power at the main breaker or service disconnect
switch before working on the circuit.
Lock-out and tag the breaker to indicate that work is being
performed on the circuit.
Changing Wire Connections in the Lower Junction Box
The direction change requires that the rack switch and the final rinse switch connections must
be reversed on the terminal bock located behind the front panel of the machine.