Filter
Top Products
24
1. Remove white protective film from the dishwasher exterior.
2. Install lower panels to the dishwasher.
3. Remove any foreign material from inside of the machine.
4. Check dishwasher drain/overflows are closed and in securely seated.
5. Install scrap screens, spray arms and pawl bar.
6. Turn main utilities to the dishwasher ON. (Power, water).
7. Make sure doors are closed.
8. Turn dishwasher power switch ON.
9. Check tank water temperatures reach proper levels.
10. Check for leaks.
11. Drain the dishwasher and check that floor drains handle the water volume leaving
the dishwasher.
12. Push the Start button.
13. Open each dishwasher door to make sure the safety switch stops the conveyor.
14. Restart the dishwasher.
15. Insert an empty dish rack into the load end of the dishwasher.
The pumps and conveyor will run.
16. Allow the dish rack to travel to the unload end of the dishwasher. The final rinse
will run.
17. Allow the rack to exit the dishwasher. The dishwasher pumps should run an
additional 90-seconds and stop.
18. Push the Stop button when the machine is running and the dishwasher should stop.
19. Push the dishwasher Power Switch OFF. The dishwasher should shut down.
Initial Start-Up
Check list