Mr. Coffee ECMP2 Espresso Maker User Manual


 
4.
Place
the
filter
holder
underneath
the
brew
head
so
that the handle
is
positioned
to
the
left off
center. Lift
the
filter
holder
up and
Insert
into
the
brew head and
turn
to the right.
Make sure the filter holder is
positioned
to the
right
of
the
“min
(minimum)
mark. The filter holder
must
be
secure. See figure 2.
Brewing Espresso...
FIGURE 2
1.
2.
3.
4.
5.
Remove
the
water reservoir and
fill
to the top of
the
water reservoir capacity (29 ounce capacity)
and place into
the
tank securely. Close
Iid.
Make sure the drip grate on the drip tray is in --
place.
Align either one or two demitasse cups under
the filter
holder
on the
drip
tray.
I
Make sure the steam control knob
is
in
the
OFF position,
the
on/off
switch
is
OFF
and
the
brew switch is on the “0” OFF
position.
See figure 3.
,
Plug
the
power cord
Into
an electrical
outlet.
FIGURE
3
Turn
the
on/off
switch ON. The brew light will
illuminate to let you know
the
machine is on.
When
the
brew light shuts off, turn
the
brew
switch to
the
CUP position. The machine is now
ready to brew espresso. Espresso will begin to
flow in a few seconds. Do not remove the filter
holder at any time during the brewing
process. Do not let
the
pump run with an
empty water container.
This
can damage the
pump permanently.
When
the
demitasse
cup(s) are about half full
(about
l-1/2
ounces) press the brew switch to
the
OFF
“0’
position.
Turn the on/off switch OFF. If you are making cappuccino leave
the
on/off
switch ON to froth
milk.
(See page
8
for
making
cappuccino).
7.
Unplug
the
power cord and allow the machine to cool.
8.
To make additional cup(s) and
after
the
machine
has cooled down,
remove
the
filter
holder from the brew head CAUTION: The metal
parts
of the
filter
holder might
still
be
very
hot.
Also there may be
hot water
floating
on the top
of the
filter
basket. Hold the filter holder
,
steady; Using the filter retainer clip to secure
the
filter basket in
the
filter holder, turn
the
filter
holder upside down to empty
Rinse
the filter
basket and holder
with
cold water.
8.
Remove the water reservoir using the
attached
handle.
Discard
any
excess water.
9.
Carefully remove
drip
tray and grate and clean any excess water or
espresso
that
has accumulated.
10. See for cleaning on page 10.
7