Filter
Top Products
STXD6i RIDE-ON TROWEL • OPERATION MANUAL —REV. #0 (03/23/12) — PAGE 21
INSPECTION
ENGINE OIL
Figure 7. Engine Oil Check and Fill
1. When checking or adding oil, place the machine so
the engine is level.
2. Pull the engine oil dipstick from its holder, (Figure 7).
3. Determine if engine oil is low. Oil should be between
the upper limit and lower limit (add oil) lines.
4. If oil is below the "Add Engine Oil" line add oil up
to upper limit on the dipstick. Allow enough time for
any added oil to make its way to the oil pan before
rechecking.
NOTICE
The following sections are intended to assist the
operator with inspection of the STXD6i Ride-On Trowel.
It is extremely important that these sections are read
carefully before attempting to use the trowel in the field.
DO NOT use your Ride-On Trowel until these sections
are thoroughly understood.
WARNING
Failure to understand the operation of the STXD6i
Ride-On Trowel could result in personal injury or severe
damage to the trowel.
ENGINE OIL
FILLER CAP
ENGINE OIL
FILLER CAP
DIPSTICK
F
L
ADD OIL
FULL
CAUTION
DO NOT overfill the oil pan with engine oil. Always keep
the engine oil level between the upper and lower limit
lines on the dipstick.
HYDRAULIC OIL
1. Check the hydraulic oil condition through the sight glass
(Figure 8) Replace hydraulic oil if dirty or if bubbles
are present.
Figure 8. Hydraulic Oil Sight Glass
2. Determine if the hydraulic oil is low. The hydraulic tank
has an elevated overflow bottle. DO NOT remove the
fill cap when the oil is hot or spillage will occur.
3. To add hydraulic oil, remove fill cap on the hydraulic
tank. Fill to overflow with hydraulic system cool. Use
Chevron AW / MV ISO 68 or equivalent.
HYDRAULIC OIL
SIGHT GLASS
CAUTION
Hydraulic oil can get HOT! ALWAYS allow
hydraulic oil to cool before removing fill
cap.
CAUTION
Removal of the fill cap when oil fills the
sight glass will cause hydraulic oil to spill.
Clean up hydraulic oil spills immediately.