Filter
Top Products
5
www.napoleongrills.com
Leak Tesng Instrucons
WARNING! A leak test must be performed annually and each me a cylinder is hooked up or if a part
of the gas system is replaced.
WARNING! Never use an open ame to check for gas leaks. Be certain no sparks or open ames are
in the area while you check for leaks. Sparks or open ames will result in a re or explosion, damage to
property, serious bodily injury, or death.
Leak tesng: This must be done before inial use, annually, and whenever any gas components are replaced
or serviced. Do not smoke while performing this test, and remove all sources of ignion. See Leak Tesng
Diagram for areas to check. Turn all burner controls to the o posion. Turn gas supply valve on.
Brush a half-and-half soluon of liquid soap and water onto all joints and connecons of the regulator, hose,
manifolds and valves.
Bubbles will indicate a gas leak. Either ghten the loose joint or have the part replaced with one recommend-
ed by the Napoleon Customer Care department and have the grill inspected by a cered gas installer.
If the leak cannot be stopped, immediately shut o the gas supply, disconnect it, and have the grill inspected
by a cered gas installer or dealer. Do not use the grill unl the leak has been corrected.
Propane Cylinder Installaon: Pull out the tank drawer (do not disengage slides). Set cylinder inside tank ring.
Natural Gas Hook-Up: These connecons must be made by a licensed gas installer. This natural gas grill is sup-
plied with a 12 foot. (3.6 meter) supply hose and quick disconnect designed for natural gas and cered for
outdoor use. The gas grill is designed to operate at an inlet pressure of 4.5 in. water column. Piping and valves
upstream of the quick disconnect are not supplied. The installaon must comply with CAN B149.1 Natural Gas
and Propane installaon code in Canada, or to the Naonal Fuel Gas Code, ANSI Z223.1 in the United States.
The gas supply pipe must be suciently sized to supply the BTU/h specied on the rang plate, based on the
length of the piping run.
The quick disconnect must not be installed in an upward direcon and a readily accessible manual shut-o
valve must be installed upstream of, and as close to, the quick disconnect as is feasible. The ared end of the
hose must be connected to the unit as illustrated in the Natural Gas Hose Aachment diagram. Leak test all
joints prior to using the gas grill.
WARNING! For your safety, conversion kits are not available. It is manufactured to exact specica-
ons. Any aempt to convert your grill will void your warranty. Failure to follow these instrucons could
result in property damage, personal injury or death.
WARNING! A leak test must be performed annually and each me a cylinder is hooked up or if a part
of the gas system is replaced.