Nu-Vu PMA 5/18 Oven User Manual


 
OPERATING INSTRUCTIONS PMA–5/12 AND PMA–5/18 OWNER'S MANUAL
NU–VU® FOOD SERVICE SYSTEMS MENOMINEE, MICHIGAN 49858
page 10 SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322 (906) 863-4401
TIMER INSTRUCTIONS:
A. The Power Switch must be in the ON position with the
LEDs in the Timer Display Window showing 000.
B. Press either the UP or DOWN Time Set key to enter the
desired time in minutes and seconds. The set time will
appear in the Timer's Display Window.
C. Start the Timer by pressing the Start-Stop key once. The
Timer will count down one second at a time, flashing the
remaining
time in the Display Window. Pressing the Start-
Stop key a second time will halt
the Timer; the remaining
time will flash in the Display Window. Pressing the Start-
Stop key again will restart the Timer.
D. When the set time expires the Display Window will flash
000 and the Timer Alarm will sound; the operator can silence the Alarm by pressing the Start-Stop
key. After the Alarm is turned OFF the Timer will automatically reset itself to the last entered time.
Pressing the Start-Stop key will restart the Timer.
OPERATIONAL NOTES:
The entered time changes by 1 second with each "click" of a Time Set key. Holding either key down
changes the time by 1-second increments for the first 35 seconds of change, 10-second increments
for the next 8 minutes of change, and 1-minute increments for the remainder of the change to a
maximum set time of 99 minutes and 00 seconds (99:00 in the Display Window). Releasing the
Time Set key restores the 1-second increment of change.
The time setting can only be edited when the Timer is not
running.
A Timer can be reset at any time during the cooking cycle by holding the Start-Stop key for 5
seconds; Timer to its original set time. The set time can now be edited, or the Timer can be restarted
to count down from this point.
This digital Timer contains a short-term
memory chip to prevent the loss of a Timer setting because
of an accidental shut-down of the unit. The Timer will recall the last entered setting when the unit is
restarted.