Filter
Top Products
31
Figure 2
Figure 1
REMOVING AND REPLACING THE OVEN DOOR
• Fully open the oven door and rotate the stoppers all the
way back (Figure 1).
• Slowly close the door until the clips are pressed against
the supports. At approximately 15° (relative to the closed
door position), pull the door slightly upward and pull them
out from both hinge supports on the appliances (Figure 2).
• Replace the door in the reverse order. Insert the door
under an angle of 15° into the hinge supports at the front
side of the appliance and push them downwards to the
front until they slide into their supports.
• Then, completely open the door and rotate the attachment
clips back to their initial position. Slowly close the door
and check, if they close properly. If the door does not open
or close correctly, ensure the hinge notches are correctly
placed in their hinges.
Attention
Always ensure the hinge attachment clips are secured in their
supports when installing the door. Otherwise, the main hinge
that is operated by a strong spring may be released while
installing or removing the door and there is a risk of physical
injury.