Filter
Top Products
- 11 -
English
How to Operate NE-2156-2/NE-1656
H. CYCLE COUNTER
✐ For selecting length of tone “short beeps for 60 seconds”:
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
Follow step 1-4 on page 9. DO NOT CLOSE THE DOOR!
PROG
1
5
Within three seconds after pressing Prog pad at step 4, press
Number/Memory pad “0” once.
☛ “PROG” will start to blink and 2nd Stage Heating Indicator “2” (the
length of beep tone “short beeps for 60 seconds”) will be indicated.
0
PROG
2
6
Press Prog pad.
☛ “PROG” will stop blinking. This means that you have completed
programming.
Three seconds later, “0” will appear.
PROG
2
• Close the door. One minute later, Digital Display Window will go blank.
G. PROGRAM LIST
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Open the door and leave it open.
☛ The oven lamp will turn on and “0” will appear.
2
While pressing Stop/Reset pad, press Start pad.
☛ All currently programmed information (the program set into each
Number/Memory pad (A/B sides), Beep Tone, and Program Lock
information) will continuously appear.
+
e.g.
PROG
PROG
1
PROG
1
PROG
2
Example:To select short beeps for 60 seconds
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Open the door and leave it open.
☛ The oven lamp will turn on and “0” will appear.
2
While pressing Stop/Reset pad, press Number/Memory pad “3”.
☛ The times that the pressed Number/Memory pad has been used will
appear.
+
3
e.g.
◆
To Read The Number of Times Each Memory Pad Has Been Used:
Example:To read times of Number/Memory pad “3” at A side (6666 times used)
Note
:
• When you want to read the times of each pad at B side, press Shift (A/B) pad while the display is still showing
the number of cycles in step 2.