Filter
Top Products
- 12 -
How to Operate NE-2156-2/NE-1656
I. AIR FILTER
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Open the door and leave it open.
☛ The oven will turn on and “0” will appear.
2
While pressing Start pad, close and open the door.
3
Press Number/Memory pad “3”.
☛ The currently programmed hour will appear.
3
e.g.
4
Press Number/Memory pads “6”,“0” and “0”.
☛ The programmed hour will appear.
Note:up to 9999 hours
0 06
e.g.
5
Press Prog pad.
☛ Three seconds later, “0” will appear.
To check the total number of hours used,
◆ Open the door and leave it open.
◆ Press Number/Memory pad “3” while pressing Start pad.
◆ The total number of hours used and “H” will appear in Digital Display Window.
e.g. If the oven has been used for 20 hours,
Three seconds later, “0” will appear in Digital Display Window.
Note: If the oven cuts out after short operation, check if Air Filter is clean before calling an engineer.
Note:When “FILT” sign appears in Digital Display Window, remove Air FIlter and clean it with soapy water. Press
Stop/Reset pad to clear the display.
Example:To program cleaning Air Filter every 600 hours
3
Close the door while the display is still showing the number of
cycles that each pad has been used.
☛ The total cumulative cycles that the oven has been used in
Number/Memory pads at A/B sides and manual mode will appear.
e.g.
◆
To Read Total Cumulative Cycles That The Oven Has Been Used:
INSTRUCTIONPAD
DIGITAL DISPLAY WINDOW
◆
To Read The Number of Cycles That The Oven Has Been Used In Manual Mode:
INSTRUCTIONPAD
4
Open the door and leave it open.
☛ The oven lamp will turn on and “0” will appear.
5
While pressing Stop/Reset pad, press Power Level Selector pad.
☛ The times that the oven has been used in manual mode will appear.
+
e.g.
DIGITAL DISPLAY WINDOW