Filter
Top Products
I Installationand GroundingInstructions I
Examine YourOven
Unpack oven, removeall packing material and exam-
ine the oven for any damage such as dents,broken
door latches or cracks in the door. Notifydealer imme-
diately ifoven isdamaged. DO NOT install ifoven is
damaged.
Placement of Oven
1, Oven must be placed on a flat, stable surface. For
proper operation,the even must have sufficient air
flow. Allow 3-inches (7.6 cm) of space on both sides
of the oven and 1-inch (2,5 cm) of space on top of
oven.
a. DO NOT block air vents.
If they are blocked during operation, the
oven may be overheated and damaged.
When using any cloth over the oven, the air
intake and exhaust should not be blocked.
Also should allow space on back and both
sides of oven properly.
b. DO NOT place oven near a hot, damp surface
such as a gas or electric range, or dishwasher.
c. DO NOT operate oven when room humidity is too
high.
2.This oven was manufactured for household use only.
3.This oven maybe built into a wail cabinet, ifdesired,
by usingthe proper trim kit, which may be
purchased from a local dealer, Follow all installation
instructionspacked with the kit.
Installation
1. DO NOT block air vents, if they are blocked during
operation, theoven may overheat, If the oven
overheats, a thermal safety device will turn the oven
off. The oven will remain inoperable until it has
coo_ed.
2. This oven was manufactured for household use only.
Grounding Instructions
This appliance must be grounded. In Ihe event of an
electricalshort circuit, grounding reduces the riskof
electric shock by providing an escape wire for the elec-
tric current. This appliance is equipped with a cord hav-
ing a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNINGIImproper use of the grounding plug
can result in a risk of electric shock.
Consult a qualified electrician or service person if the
grounding instructionsare not completely understood,
or g doubt exists as to whether the appliance is proper-
ly grounded. Itit is necessary to use an extension cord,
use only a three wire extension cord that has a three
blade grounding plug, and a three slot receptacle that
will accept the plug on the appliance. The marked rat-
ing of the extension cord should beequal to or greater
than the electrical rating of the appliance.
Power Supply
1.Ashort power-supply cord is provided to reduce the
hsks resulting from becoming entangled inor tripping
over a longer cord.
2. Longer cord sets or extension cords are available
and may be used if careis exerdsed in theiruse
3 Ifa long cord or extension cord is used, (1)the
marked electrical ratingof the cord set orextension
cord should be atleastas great as the electrical rat-
ing of the appliance, (2)the extension cord must be
a grounding-type 3-wire cord, and (3) the tonger cord
should be arranged so that itwill not drape over the
counter top or tabletop where it can be pulled on by
children or tripped over accidentally.
Wiring Requirements
1.The oven must be on a SEPARATE CIRCUIT. No
other appliance should share the circuit with the
microwave oven, If itdoes, thebranch circuit fuse
may blow,the circuit breaker may trip, or the food
may cook slower than the times recommended in
thismanual.
2. The VOLTAGE used must be the same as specified
onthis microwave even (120 V,60 Hz). Using a
higher voltage is dangerous and may result ina fire
or other incidentcausing oven damage. Using a
lower voltage will cause slow cooking. Panasonie is
NOT responsible for damage resulting from the use
of the oven with other than the specified voltage.
3 The oven must be plugged into at leasta 20AMP,
120 VOLT,60 Hz GROUNDED OUTLET. Where a
standard two prong outlet isencountered, it is the
personal responsibility and obliga-
tion of the consumer to have it r=='==_
replaced with a properly
grounded three-prong outlet.
TV/ Radio Interference
1. Operation of the microwave oven may cause inter-
ference to your radio, TV or similar equipment,
2. When there is interference, itmay be reduced or
eliminated bytaking the following measures:
a. Clean door and sealing surfaces of the oven.
(SeeCare of Your Microwave Oven)
b. Placethe radio,TV, etc. away from the
microwave oven as far as possible.
c. Use a propedy installed antenna to obtain
stronger signal reception.
Glass Tray
1, DO NOT operate the oven without Roller Ringand
GrassTray inplace
2. DO NOT operate the oven without the GlassTray
fullyengaged on the drive hub. Improper cooking or
damage to the oven could result. Verify that the
Glass Tray is properly engaged and rotating by
observingits rotation when you press Start.
3. Only use the Glass Tray specifically designed for this
oven. Do not substitute any other glasstray.
4. If the Glass Tray is hot, allow to cool before cleaning
or placing in water,
5 DO NOT cook directly on the Glass Tray.Always
pJacefood in a microwave-safe dish, or on a rack set
ina microwave-safe dish
6 Iffood or utensil on the Glass Tray touches oven
walls, causing the tray to stop moving, the tray will
automatically rotate in the opposite direction This is
normal.
7, Glass Tray can turn in either direction.
Roller Ring
1 Roller Ring and oven floor should becleaned fie-
quenlly to prevent excessive noise
2. Roller Ring must always be used for cooking along
with Glass Tray.
3 Always replace Roller Ringand Glass Tray intheir
proper positions.
3