Filter
Top Products
7
perlick.com
PERLICK RESIDENTIAL INSTALLATION MANUAL
Maintenance
seasonal Maintenance for ul-aPProved
outdoor Models
Winterizing
This process should occur when the daily low
temperatures is at or below the temperatures stated
below:
Freezer models: 32° F
Refrigerator models: 38° F
Beverage Center: 42° F
Wine Reserve: 45° F
It is best to winterize your unit before the low
temperatures listed above.
1. Turn the unit to OFF position by pressing the OFF
button on the controller. The controller displays the
word “OFF” and, for Signature Series models, turn the
master switch located behind the grille o (if the power
cord is accessible, unplug the power cord. If not, turn
o the circuit breaker to the electrical receptacle the
cabinet is plugged into). For C-Series units, unplug or
turn o the circuit breaker.
2. Remove all contents from the unit.
3. Remove the front grille.
4. Clean the condenser by using a vacuum cleaner to
remove loose debris (leaves, dirt, etc.) that may have
accumulated inside the grille.
5. Reinstall the front grille.
6. Clean the interior of the unit using stainless steel cleaner
and polish (see page 9).
7. Clean the exterior of the unit using stainless steel
cleaner and polish (see page 9).
NOTE: Do not place a cover over the unit. While not required, you
may choose to remove the unit from the outdoor location and store
indoors.
Operating the unit at temperatures lower than those
recommended will void the warranty.
CAUTION
Spring Start-Up
This process should occur after the daily low temperatures
is below the temperatures stated below:
Freezer models: 32° F
Refrigerator models: 38° F
Beverage Center: 42° F
Wine Reserve: 45° F
1. Remove the grille.
2. Check the condensing unit to ensure it is clear of loose
debris, and clean as necessary with a vacuum cleaner.
3. Reattach front grille to the unit.
4. Clean the interior of the unit using stainless steel cleaner
and polish (see page 9).
5. Clean the exterior of the unit using stainless steel
cleaner and polish (see page 9).
6. Plug the unit into the electrical receptacle or turn on
the circuit breaker.
7. Turn on the master switch located behind the grille if
model is Signature Series. Press the OFF button one
time to turn the unit on. The controller display will show
the actual temperature inside the cabinet.
8. The cooling process will begin to bring the unit to the
set temperature. It’s recommended you run the unit for
24 hours to stabilize the operating temperature before
using.
DANGER
Never attempt to repair or perform maintenance on
the unit until the main electrical power to the unit has
been disconnected!
led rePlaceMent (signature series)
Call your Perlick Factory Authorized Service Center. For the
location of the Service Center in your area, contact your
selling dealer, inquire via the web at www.perlick.com,
E-mail us at warrantyserv@perlick.com, or call
(800) 558-5592 during normal business hours.
ligHt bulb rePlaceMent (c-series,
ada-coMPliant & sHallow-dePtH series)
To replace a defective or burnt out bulb, remove the glass
light cover by pulling out on the cover, unscrew the bulb
and replace it with an identical or smaller bulb. The Perlick
replacement part number is 67026.