Philips HD8743 Coffeemaker User Manual


 
38
ENGLISH
Light Signals Causes Solutions
Steady on
The co ee bean hopper is empty. Fill the coffee bean hopper with coffee beans and start the
procedure again.
The co ee grounds drawer is full. With the machine turned on, empty the co ee grounds drawer. If
the co ee grounds drawer is emptied with the machine turned o
the co ee cycle counter is not reset. Wait until the
“ ” light starts to
 ash before placing back the co ee grounds drawer.
Quickly fl ashing
The water circuit is empty. Fill the water tank with fresh water and dispense hot water as
described in Section “Using the Machine for the First Time”.
Slowly fl ashing
Brew group is not inserted. Coffee ground
drawer is not inserted.
Service door is open.
Control dial is not in correct position.
Make sure that all components have been correctly inserted and
closed. The  ashing “ ” light will now turn o .
Flashing in counter-clockwise
direction
The machine is performing the rinse/self-
cleaning cycle.
The machine ends the rinse/self-cleaning cycle automatically.
You can interrupt the rinse/self-cleaning cycle by pressing
either buttons
Flashing alternately
A fault has occurred in the brew group. Try again to brew another espresso or a co ee.
Flashing
simultaneously
The machine is out of order. Turn the machine o . After 30-seconds, turn it back on.
Try this 2 or 3 times.
If the machine does NOT start, contact the Philips Saeco hotline.