Filter
Top Products
40
ENGLISH
Problem Possible Cause Solution
The coee is too weak (see
note).
This may sometimes occur when
the machine is automatically
adjusting the dose.
Brew a few espressos as described in
the section “Saeco Adapting System”.
The ceramic coee grinder is set
to a coarse grind.
Adjust the ceramic coee grinder to
a ner setting (see section “Adjust-
ing the Ceramic Coee Grinder”)
Coee is brewed slowly (see
note).
The coee grind is too ne. Change coee blend or adjust the
grind as explained in section “Adjust-
ing the Ceramic Coee Grinder”.
The water circuit is not primed. Fill the water tank with fresh water
and dispense hot water.
The brew group is dirty. Clean the brew group (section
“Weekly Cleaning of the Brew
Group”).
The drip tray gets lled al-
though no water is drained.
Sometimes water is drained auto-
matically by the machine into the
drip tray to manage the rinsing of
the circuits and ensure optimum
machine performance.
This is seen as normal machine
behaviour.
Note:
These problems can be considered normal if the coee blend has been changed or if the machine has just been
installed. In this case wait until the machine performs a self-adjusting operation as described in section “Saeco
Adapting System”.