Filter
Top Products
3-2
WARNING
DANGER - HIGH VOLTAGE PRESENT
NEVER remove fuses from the cooker until the cooker is unplugged
from the facility power supply.
a. To check and replace heating element fuses:
1. Unplug the cooker from facility power source.
2. Remove screw to fuse access door on back panel of the cooker.
3. The heating element fuses are mounted in a fuse holder located behind the rear access
panel.
4. Remove each fuse by gently pulling the fuse straight out of the holder using a fuse
puller.
5. Use an ohmmeter set on "x 1" ohms (resistance) setting to check the fuses for
continuity. For a GOOD fuse, the meter reading should be approximately zero "0"
ohms. If the reading is significantly above zero ohms, replace the fuse.
6. Replace each fuse by pushing the fuse straight into the fuseholder until it locks in
place.
7. Lower fuse access door.
8. Replace screw and tighten.
9. Plug the cooker into the facility power source.