Filter
Top Products
Solstice I12 Water Cooker Computer Service
Part #60153301
L20-316 Rev 0
5
2 To Enter Programming Level 1 (for the Store Manager):
Note: The factory default setting for this control does not require an operator password to be
entered. However, the operator password requirement and value may be changed in
section 3.2. Both examples are shown in the next steps. Entry of a password when NOT
required will not interfere with the programming process.
With no cooks or holds timers running, displays will show one of the following displays: [HEATING] or
[READY]. Press the key.
If displays shows:
Enter password
Level 1 & 2 Password
using the location
keys as a numeric keypad for entry. Display will
show .
If display shows:
; you do not need to
enter a password.
From this [PROGRAM] display, continue with this section or go to sections 3 or 4.
2.1 To Set Cook Temperature:
Press the thermometer key.
The display will show [SET tttF] [TEMP] or [SET tttC] [TEMP], where “ttt” is the temperature setting.
Use the location keys for numeric entry to adjust the current setting. Press the key to save
setting. The display now shows [PROGRAM]. To exit here, press again, or continue.
2.2 To Change a Product Key–Cook, Shake, Hold and Hold Pre-Alarm Times, and Name:
Cook, Shake, Hold and Hold Pre-alarm times, and key names are set in the following steps. With
display showing [PROGRAM], continue with the following section for each product key to change.
Follow these steps for each product key.
2.2.1 Cook Time
Cook Time may be set for each product key. Press the key; display will show [SELECT]
[PRODUCT]. Press the desired product key to change.
The display is now showing [C hh.mm:ss] [NAME nn ] where “nn” is the default key number,
“C” means Cook, and “hh.mm:ss” is hour, minutes and seconds. Use the location keys for
numeric entry to adjust the current setting. Press the key to save Cook Time and
continue with Shake Time for this product key.
Note: To deactivate any product key, enter a zero value for Cook Time.
2.2.2 Shake Time
Shake Time is an alarm that sounds during Cook Time to prompt operators to shake the basket
or warn that Cook Time is about to end. Default for this value is zero, meaning the Shake Time
is inactive. To use Shake Time, time value must be a non-zero value, and must be set to a
value less than Cook Time.