Filter
Top Products
Steamer 625-502revA
Printed in USA 0910 © 2003
2
Steamer
625-A
Installation
Operation
Safety Information
Remove the unit from the carton and inspect for signs of damage. If
there is damage to the unit:
• notify the carrier within 24 hours of delivery
• save carton and packaging materials for inspection purposes
• contact your local dealer, or if purchased directly, the Prince Castle
Sales Department at 800-722-7853 or 1-630-462-8800 to arrange for a
replacement unit.
WATER CONNECTION REQUIREMENTS
If this is a new installation, accessory - 625-104 Regulatory Assembly Kit
is required. You may also need accessory part #625-103 Coil Hose Kit
Assembly. Always use area codes for determination.
Plug the unit into an applicable electrical receptacle.
Connect the water line to the back of the unit.
Prince Castle reserves the right to change
specifications and product design without
notice. Such revisions do not entitle the buyer
to corresponding changes, improvements,
additions or replacements for previously pur-
chased equipment.
prince castle
8
filet
remove
1
3
2
4
A. Turn unit power On/Off switch to ON position. The display
flashes PRINCE CASTLE for ten seconds.
B. After ten seconds the display will show PR.E-HEAT.
NOTE: The next-to-left most decimal point appears
indicating power is applied to the platen. Platen will heat to the
setpoint temperature.
Place the spatula fully into the unit and press the START button.
The display will start to count down the steam cycle.
A. When the unit reaches the setpoint temperature, display will
show the product name assigned to button 1.
B. If 1 is the desired product to be steamed, pull out the
spatula and place the product onto the spatula, cut side
down.
Or
press product buttons 2, 3 or 4, then place product on the
spatula, cut side down.
When steam cycle is complete, the unit will sound a tone and
the display will flash REMOVE.
Pull out the spatula and remove the finished product.
WARNING
Indicates information important to the proper opera-
tion of the unit. Failure to observe may result in dam-
age to the equipment and/or severe bodily injury or
death.
CAUTION
Indicates information important to the operation of
the unit. Failure to observe may result in damage to
the equipment.
Important
CAUTION
All electrical connections must be in accordance with local electrical
codes and any other applicable codes.
CAUTION
Water connection must provide maximum water pressure of
20-30 psi (138-207 kPa).
pr.e-heat
NOTE: When installing this unit, the ambient temperature at the
mounting site should not exceed 37.8°C (100°F) .