Filter
Top Products
Steamer 625-502revA
Printed in USA 0910 © 20037
Steamer
625-A
4
Pour a solution of Delimer into the steam chamber.
Let solution soak for at least 15 minutes.
5
A. Clean stem injection ports with a paper clip or small wire.
B. Rinse with clean water.
C. Wash all external surfaces of the steamer with a solution of
detergent and water in a spray bottle.
Spray directly onto a clean sanitized towel and wipe
the unit clean.
D. Reassemble the unit.
2
A. Remove spatula.
B. Remove the top
plate by carefully
sliding it forward
and out of the unit.
C. Remove the
venturi plate.
Cleaning - Monthly PM Tasks
The following equipment is required:
• Detergent or Cleaning Solution
• Delimer/Lime Scale Remover
(as required)
• Sanitizer
• Clean sanitized towel
• Protective (insulated) gloves
Top Cover
Top Plate
Venturi Plate
Spatula
1
While wearing protective gloves, remove the top cover by
pulling up and off the unit.
3
A. Wash top cover, top plate, spatula, and venturi plate in a
solution of detergent and water.
B. Rinse with clean water, and then sanitize in a solution of
sanitizer.
C. Let air dry.
IMPORTANT. It is not recommended
to leave open container of delimer around
While wearing protective gloves:
CAUTION
Do not spray directly on the unit or use abrasive cleaners!
WARNING
Turn the unit off and unplug the power cord from the electrical recep-
tacle. Proceed with caution, unit is still hot!
CAUTION
This unit is not watertight. Do not clean with a water jet/jet spray. Do
not immerse the unit in water.
Do not use abrasive materials such as scrapers, steel wool, etc. to
clean the spatula or steam chamber.