Radio Shack 32-2057 Mixer User Manual


 
11
The Basics
Notes:
Write down the CH setting for each audio source. Then,
when you want to mix that source, you can adjust its
volume to that setting.
If it was necessary to set CH 1 to maximum to get a reading
of 0 or less on the LED meter, slide CH 1 down to about 8 and
adjust MASTER upward until you get a reading of 0 on both
LED meters.
presetting the microphone
1. Turn on your microphone.
2. Set OFF/ON/TALKOVER to ON.
3. While talking, adjust DJ MIC until you get a signal reading
of up to 0 on both LED meters.
4. Set OFF/ON/TALKOVER to OFF.
MIC — connect a microphone
with an XLR plug here
DJ MIC — adjusts volume of
the microphone connected to
the MIC jack.
OFF/ON/TALKOVER
MASTER —adjusts overall
volume of sources connected
to DJ MIC, CH1, CH2, and CH3.