Filter
Top Products
9
The Basics
using your mixer
1. Set your output source’s volume to minimum and turn it
on.
2. Press POWER to turn on the mixer.
3. Turn on the audio input sources you want to mix.
4. Preset the input signal levels and mix your audio input
sources. Refer to the next two sections for details.
5. When you are finished, turn off all connected audio
sources (amplifiers, tape decks, and so on), and press
POWER to turn off the mixer.
presetting input signal levels
To avoid overdriving a channel or prematurely mixing an
audio input source, adjust your mixer to these settings:
ASSIGN A and ASSIGN B set to OFF.
CH 1, CH 2, and CH 3 set to 0.
MIC TREBLE and MIC BASS set to 0.
MASTER set to about 5.
CUE LEVEL set to 0.
POWER
For monaural output, set MONO/STEREO to MONO.
For stereo output, set MONO/STEREO to STEREO.