9
Interrupting the programme
Note: Interrupt or cancel a programme in progress ONLY
when absolutely necessary.
Interrupting a programme in progress
Caution! There is a risk of water coming out from
inside the appliance. DO NOT open the door fully
until the spray arm has stopped rotating.
Open the door. When you open the door, the dishwasher will
beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was
switched ON and then the appliance door opened, leave the
door ajar for several minutes and then close, otherwise the
door may open due to expansion.
Close the door. After 30 seconds the programme will start
from the point it was interrupted.
Cancelling a programme in progress
Open the door. The dishwasher will beep and the programme
indicator will blink with the time remaining indicator
displaying ‘E1’.
Press the programme button and hold it in for about
3 seconds; the dishwasher will emit one short warning sound.
The drain phase will start and the programme indicator light
will flash, indicating that the running programme has been
cancelled.
Delayed start programming
You can delay the start of a programme from 1 hour up to
24 hours.
1. Switch the dishwasher ON.
2. Press programme button to choose the desired
programme.
3. Immediately press the Delayed Start button
(Fig.2-17), the delayed start indicator illuminates; the
time remaining indicator (Fig.2-18) changes to ‘1’.
4. Press the Delayed Start button as many times as
necessary until the numerical display shows the
required delay.
5. To cancel the time delay setting, pressing the Delayed
Start button until the delayed start indicator and time
remaining indicator go out.
6. Close the door; the time remaining indicator will blink
and start to count down. The programme will start
when the delayed start indicator goes out and the wash
cycle will begin.
To cancel a delayed start programme in progress, follow the
‘Cancelling a programme in progress’ instructions.
ArtNo.800-219
- RDW6015
- Delayed start
Fig.2-17
Fig.2-18