Filter
Top Products
USERS GUIDE
Page 15
Ventilation
The appliance housing used must
provide adequate ventilation in
accordance with the manufacturer’s
recommendations as detailed in the
installation diagrams above. For built-in
installation, a minimum ventilation cut-
out of 400cm² must be incorporated into
the support shelf beneath the oven
together with a 500mm x 15mm cut-out
along the upper edge of the housing
unit’s plinth. A further ventilation space
of 85 90mm must exist between the rear
of the appliance and the back of the
housing or an adjacent wall. If a tall
housing is to be installed flush with the
ceiling, a 20cm² ventilation cut -out must
be provided at the top of the housing.
When placing the oven in the housing,
do not use the oven door as a lever for
lifting the oven as damage may result.
Once the oven has been positioned in the
housing it should be secured in place at
the four corners of the oven doorframe
using suitable screws (see diagram).