Filter
Top Products
Servicing Notes
Disconnect from electricity supply before
commencing servicing, particularly before removing
any of the following: control panel, side panels,
ceramic hob, or any of the electrical components or
cover boxes. Before electrical reconnection check that
the appliance is electrically safe.
Disconnect from electricity supply.
Pull the cooker forward.
Pull off the push fit control panel end caps at each end and
remove the end fixing screws under the end cap.
Remove the retaining screws for each panel (1 at the front
and 2 at the rear). The lower front retaining screws (one
each side) are situated beneath the lower edge at the front
corners of the side panels
Reassemble in reverse order.
Pull the cooker forward.
Unscrew the 2 screws which are loacted at the rear of either
side of the cooker underneath the grill trim
Push the hob backwards to release the front catchment
bracket.
Lift the hob.
Hold the hob in place using the rod attached to the
underside of the hobplate, by locating the loose end into
the central hole in the top of the inner control panel.
Caution
Lift up the ceramic hob at the front and prop in position
with a non-metallic prop.
Lift up the ceramic hob see 2. The elements are now
accessible.
Disconnect from electricity supply.
Remove the handrail by removing the 2 end bracket fixing
screws.
Pull off the push fit control panel end caps at each end and
remove the end fixing screws under the end cap.
Pull off all the control knobs. Open the grill and oven doors
and remove the control panel fixing screws underneath the
control panel. The screws directly below the clock are for
the clock fixing bracket - don’t remove them at this stage.
Lift the control panel, pull forward and disconnect the
wiring from the rear.
Reassemble in reverse order. When replacing leads refer to
the wiring diagram. Check operation of timer.
Remove control panel (see 4).
NB The old switch may be destroyed during removal.
Remove switch button and old switch from its bezel by
gripping the switch body behind the control panel and
twisting sharply.
The switch bezel can then be removed by folding back its
locking wings and pushing forward. Fit the new bezel to the
control panel by first lining up the raised key on its body
with the cut-out in the control panel and pushing it in from
the front. Assemble the new switch to the bezel by lining up
the key sections and pushing home. Fit the new button by
pushing in from the front.
Replace control panel in reverse order and test for correct
operation.
Disconnect from electricity supply.
Pull off the timer control buttons and remove the control
panel (See 4). Remove the timer/mounting bracket
assembly from the control panel by removing the two fixing
screws. Remove the timer from its mounting bracket by
depressing the plastic lugs on the timer case, at the same
time pulling the unit forward.
Reassemble in reverse order. When replacing leads refer to
the wiring diagram. Check operation of timer.
Lift up the ceramic hob top (see 2). Remove control panel
(see 4). Open appropriate oven door and remove oven
furniture.
Remove thermostat phial cover (2 screws). Unclip
the thermostat phial from the clips in the oven
back.