Filter
Top Products
12
Electrical Supply Connection
Your refrigerator is intended as a permanent
installation.
Connect the appliance to the electrical supply (220–240 V ~
50 Hz) with the plug and lead, which are tted.
Connections to the mains supply should be in accordance
with local regulations.
WARNING: THIS APPLIANCE MUST BE EARTHED
All external wiring must comply with the IEE Regulations
for the Electrical Equipment of Buildings. The appliance is
supplied with a 3-core cable 2 m long. If a replacement cable
is tted it must be 250 V high temperature PVC (85 °C), 1 mm².
Should the plug not t the socket in your home, it should be
removed and replaced with a suitable plug.
Note: If the plug is tted is not suitable, it must be cut o and
disposed of properly. To avoid the risk of electrocution, the
plug must not be left where children might nd it and plug it
into a supply socket.
Three pin plugs to BS 1363 with a capacity of not less than
13 A must be used and tted with a 13 amp fuse ‘ASTA’
approved to BS 1362.
You MUST ret the cover after replacing the fuse. If the cover
is lost, the plug MUST NOT be used until a replacement cover
has been obtained from your supplier. The colour of the
correct fuse carrier is that of the coloured insert in the base of
the fuse recess, or stated elsewhere on the plug. Always state
this colour when ordering a replacement fuse carrier.
IMPORTANT: The wires in the mains lead are coloured in
accordance with the following code (Fig.4-14):
Green and yellow: EARTH
Blue: NEUTRAL
Brown: LIVE
Earth: to the
terminal marked E,
coloured Green/Yellow
Live: to the
terminal marked L,
coloured Brown
Neutral: to the
terminal marked N,
coloured Blue
Fig.4-14