Filter
Top Products
-3-
Water Bottle
Boiling Chamber
AquaVié Chassis
HOW TO PREPARE YOUR
AquaVié
™
HEALTHY WATER SYSTEM UNIT
Before using your AquaVié
™
Healthy Water System unit for the first
time, please follow the steps below.
CLEAN THE WATER BOTTLE
First, make sure the dispensing valve is installed and tightened onto the water
bottle. Then fill the water bottle about
3
⁄
4 full with water. Add one or two
drops of dish detergent to the water. Do not install the mineral dispenser
at this time. Seal the bottle’s top opening with the cap supplied. Shake the
bottle vigorously and then drain. Rinse the bottle thoroughly to remove all of
the detergent.
NOTE: Do not allow the soap/water mixture to remain in the water bottle for
long periods of time. Do not use the water bottle to store liquids other than
distilled water. Liquids other than distilled water may transfer a taste or odor
to the water bottle.
TO SANITIZE WATER BOTTLE
Add 4
3
⁄
4
ounces (150 ml) of 3% hydrogen peroxide solution (H
2
O
2
) to the
water bottle. Fill the bottle with hot (160˚F/71˚C) distilled or tap water.
Do not install the mineral dispenser at this time. Cap the water bottle
and shake the vigorously. Let stand for twenty minutes then drain thoroughly.
Rinse with room temperature distilled or tap water, then drain. Water bottle
may be used immediately or allowed to air dry.
PREPARE THE MINERAL DISPENSER
To prepare the mineral dispenser, rinse it under cold running tap water for 30
seconds. Drain excess water from dispenser. Place the mineral dispenser into
the water bottle. The same cleaning process should be used whenever a new
replacement mineral dispenser is installed. The rinsing process will help remove
{
{
{
Dispensing
V
alve
Water Bottle
C
ap
B
oiling
Chamber
C
ap
Baffle
S
ecuring
N
ut
Cord
C
ooling
V
ents
M
ineral
D
ispenser
Flat
Gasket
O-Ring