Filter
Top Products
47
Chapter 6. Connecting External Devices
■
Switching Local Control on and
Off
When connecting a MIDI sequencer, set Local Control to
“OFF.”
As illustrated, information describing what has been played
on the keyboard is passed to the internal sound generator
over two different routes, (1) and (2). As a result, you hear
overlapping or intermittent sounds. To prevent this from
happening, route (1) must be severed, by setting the unit to
what is known as “Local Off.”
fig.localcont.e
Local Control ON: The keyboard and the internal sound
generator are in a linked state.
fig.localon.e
Local Control OFF: The keyboard and the internal sound
generator are in an unlinked state. No sound will be
produced by the keyboard when it is played.
fig.localoff.e
* When a Roland MT series instrument is connected, it is not
necessary to make the Local Off setting. MT units transmit
Local Off messages when their power is switched on. If you
turn on the power in the order of the DP-970
→
MT series,
Local Off will be set automatically.
1.
Hold down the [Split] button, and press the [Reverb]
button.
The DP-970 switches to the function mode.
2.
Press the [Variation] button.
The following appears in the display.
fig.disp-on
Power-up default setting
On
■
Transmitting a Performance
You Recorded
If you want to transmit a performance recorded on the DP-
970 to an external MIDI device or computer, turn this setting
“On.” If this is “OFF,” the data will not be transmitted.
1.
Hold down the [Split] button, and press the [Reverb]
button.
The DP-970 switches to the function mode.
2.
Press the [Play] button.
The following appears in the display.
fig.disp-Off
Power-up default setting
OFF
Connection Examples
Saving Recorded Performances to a MIDI Sequencer,
Such As One From the MT Series (Except the MT-90s)
Set the external MIDI sequencer’s MIDI THRU setting to
OFF. For details, refer to the owner’s manual for your MIDI
sequencer.
1.
Connect a MIDI sequencer such as the MT series (p.
46).
2.
Record the performance on the DP-970 (p. 33).
3.
Set this setting to “On.”
4.
Start recording with the connected MIDI sequencer.
5.
Start playback of the recorded song on the DP-970.
6.
When playback ends, stop recording with the
connected MIDI sequencer.
7.
Use a connected MIDI sequencer to save the data on a
floppy disk or other media.
(1)
MIDI
MIDI
MIDI
MIDI
(2)
IN
IN
OUT
OUT
Sequencer
Memory
Sound
Generator
Each note played
is sounded twice
Thru function On
Local On
Local On
Sound is emitted
Sound Generator
Local Off
No sound produced
Sound Generator
Display
Descriptions
On
Instrument is set to Local On.
OFF
Instrument is set to Local Off.
Display
Descriptions
On
Recorded performance is transmitted to
external device.
OFF
Recorded performance is not transmitted to
external device.
DP-970_e.book 47 ページ ２００７年１月１６日 火曜日 午後１時４２分