Filter
Top Products
12
To get started using your VHD-4403 ULTRA and projector, follow these simple steps:
1. Ensure all sources that you are using are properly connected to the VHD-4403
ULTRA. This is something your Runco dealer has probably already done for you;
if not, please refer to the ‘Connection Examples’ and the owners manuals of each
appropriate source as necessary.
2. Turn on all sources. If a A/V receiver or a RUNCO OVSS-8 is being used to
switch the video, ensue that is also turned on.
3. Turn on the VHD-4403 ULTRA. Make sure the Main Power switch (pg. 8) is ON,
then press the power button on the front of the controller (or the power button on
the remote). Ensure the red LED lights up on the front of the unit.
4. Turn on the projector.
5. With the left or right buttons on the front panel or remote, select the desired
source. You may also do this by going through the menu (see pg. 14).
6. Select the desired aspect ratio by using the up and down buttons on the front
panel or the remote. You may also do this by going through the menu. For an
explanation of Aspect ratios, please refer to pg. 18.
QUICK SET-UP GUIDE
Getting Started