Russell Hobbs RHDW1 (B) (S) (G) Dishwasher User Manual


 
Installation
Electrical connection
Products must be installed in accordance with the manufacturer's safety
recommendations.
Before proceeding with the electrical connection, verify that the current carrying
capacity of the system and the socket is adequate for the maximum power rating of the
dishwasher.
Electrical installation of the residence and of the appliance’s plug must be earthed and
conform with the required safety regulations.
Do not use adaptors, multiple sockets and/or extension leads.
A circuit breaker with a contact opening of at least 3 mm, rated 20A and delayed
functioning type must be installed inside the supply circuit.
Always use the coated plug supplied with your machine.
The machine’s electric cable should be replaced by a qualified electrician only. Failure to
do so may result in injury and will void the manufacturer’s guarantee
Always unplug the machine when a wash cycle has finished. Do not unplug with wet
hands. Always ensure you pull the plug, and not the cable leading into the plug.
Fitting the machine under a countertop
If you wish to fit your machine under a countertop, check whether you have sufficient
space under your countertop and whether the wiring-plumbing is suitable to do so.
1. If the space under the countertop is not sufficient for the machine to fit in it with its
worktop/top cover on it, then it can be removed. As shown in the illustration below.
10