Pull and remove the metal/plastic filter (3). Then pull the coarse filter out of the micro
filter (2). Rinse this with water under a tap and refit the metal filter. Insert the coarse filter
into the micro filter and line up the corresponding markings. Lock the micro filter into the
metal/plastic filter and turn in the direction of the arrow (4) .
Important note
Never use the dishwasher without the filter present. Incorrectly fitting the filter will
reduce the washing effectiveness of the machine.
Spray arms
Hose filter
The inlet hose contains a filter to prevent potential water debris entering the machine.
Check the filter hose from time to time and clean if necessary. To clean the filter, first turn
the tap off and then remove the hose. After removing the filter from the hose, clean this
under the tap. Insert the cleaned filter back into its place inside the hose and refit the
hose.
Maintenance
23
Always check the spray arm water outlet to ensure
they are not clogged. If these are clogged, ensure
they are cleaned.
The lower spray arm can be removed by pulling it
upwards, while the upper spray arm nut can be
removed by turning the nut to the left. Ensure the
nut is tightened sufficiently when refitting the upper
spray arm.