Filter
Top Products
Installation
2. Remove the screws that hold the worktop, these are located at the rear of the
machine. When unscrewed and removed, push the front panel 1 cm from the front
side towards the rear and lift it.
3. Adjust the feet of the machine according to the slope of the floor.
4. Place/put your machine by lifting and pushing it under the countertop without letting
the hoses get crushed or bent.
Important note
• When in place the machine should not touch the countertop or be incorrectly balance,
as it may cause damage to cabinets, the floor or the countertop.
• The machine should be fitted in a space that are the same dimensions that detailed in
the above illustration.
10