Russell Hobbs RHEC1 Cookware User Manual


 
Installation
7
Electric oven and hobs must be connected to an electrical cooker powerpoint - consult a
qualified electrician. Products must be installed in accordance with the manufacturer's
safety recommendations, in accordance to the instructions in this guide and in
compliance with the current regulations. Failure to do so will void the manufacturer’s
guarantee.
Before connecting your appliance to the mains at home, make sure to check the
conformity of the voltage settings. These are specified on the information sticker
attached to the appliance and/or packaging, with the usage conditions.
The laws, ordinances, directives and standards in force in the country of use are to be
followed (safety regulations, proper recycling in accordance with the regulations, etc.)
After removing the packaging material from the appliance and its accessories, ensure
that the hob is not damaged. If you suspect any damage, do not use the appliance and
contact an authorised service personal, qualified electrician or Product Care, (0845 208
8750), immediately.
Environment where the appliance is to be installed
To install the cooker correctly, the following precautions must be taken:
The appliance can be installed directly next to kitchen/furniture units/cabinets that are
not higher or taller than the top of the cooker’s hob.
If the Kitchen units/cabinets that will be next to the cooker are higher or taller than the
cooker, then they must be at least 200mm from edge of cooker’s hob.
If a cooker hood is installed above the cooker, it must be a minimum distance of 650mm
above the top of the cooker. The hood itself must be installed in accordance to the
instructions/requirements of the cooker hood.
Wall cabinets that are adjacent to a cooker hood must be a minimum distance of
420mm from the cooker’s hob.
If the cooker is installed beneath a wall cabinet, then the wall cabinet must be at least a
minimum distance of 700mm away from the cooker’s hob.
The cut-out or space required for the cooker is shown in the below image.