Filter
Top Products
English
10
6 - USING THE MACHINE
Important
Before operating the machine it is necessary to have read this
publication carefully and to have gained a good general
knowledge of the machine.
After a period of inactivity of the machine it is advisable to
read again chapter “5.3 before re-utilising the machine.
6.1 Machine statuses
Concerning the electricity mains, the machine can be found in one
of the following statuses:
Machine off and cut out
- Main switch (ref. 10, fig. 1) and all-pole switch in position
“0“ or plug disconnected.
- Only the stored data memory is active.
Machine on
- Main switch (ref. 10, fig. 1) and all-pole switch in position “I“
or plug connected.
- All functions are active and display (ref. 8a, fig. 1) is on.
Standby mode (machine off but not cut out)
- Main switch (ref. 10, fig. 1) in position “I“.
- Functions
“AUTOMATIC OPERATION”
, “
ANTIFREEZ-
ING”
, are active if selected, and
“CLOCK”
, as well as the
display and stored data memory.
- Diplay backlighting is off.
6.2 Manual switching on
This type of starting up is required when the machine is in the
“machine off and cut out” status (see 6.1 Machine statuses). It is
necessary to proceed as described in “5.3 First switching on” by
disconnecting the dispensed drink command, if possible.
6.3 Programmed automatic switching
on
It is possible when the machine is in
“STANDBY”
mode and the
function
“AUTOMATIC OPERATION”
is active
The machine will switch on at the preset time.
6.4 Temporary switching on from
standby
It is a manual and voluntary start, controlled by the User with the
machine in
“STANDBY”
mode.
It is obtained by pressing key for 3 seconds.
The machine will revert automatically to the
“STANDBY”
mode
60 minutes after the last operation performed.
6.5 Coffee dispensing
Briefly press (less than 1 sec.):
- key to obtain a single small cup, the display will show
“1
SMALL CUP”
;
or
- key to obtain two small cups (a double dose of cof-
fee is used), the display will show
“2 SMALL CUPS”
;
or
- key to obtain a single large cup, the display will show
“1
LARGE CUP”
;
or
- key to obtain two large cups (a double dose of cof-
fee is used), the display will show
“2 LARGE CUPS”
.
All these types of dispensing are obtained from coffee that is in-
stantly ground by the machine.
During the dispensing, the display will show
“PREINFUSION”
,
if enabled by menu (see “6.14 Menu-programmable functions”);
beside the message, an icon with a cup being filled will be dis-
played.
When the dispensing is over the display will show
“READY FOR
USE”
.
6.6 Pre-ground coffee dispensing
Use pre-ground coffee instantly loaded into the machine for pre-
ground coffee dispensing.
- Briefly press (less than 1 sec.) key once. The display will
show
“PRE-GROUND”
.
- Use the specific measuring spoon to introduce one dose of
pre-ground coffee through the pre-ground coffee slot (ref. 6,
fig. 1).
- Press key or .
The machine will behave as for a normal dispensing, utilising
the dose of pre-ground coffee manually introduced.
N.B.: Dispensing with pre-ground coffee is programmable only
for one dose.