Filter
Top Products
18
Error Codes
Error Items Code Error Beep Cause/Remedy
Cause: Power frequency is other than 60 Hz.
Remedy: • Unplug the power cord plug and check if the
power frequency is 60 Hz.
• Plug the power cord in 60 Hz power source and
see If “E1” appears. If the error code is displayed
again even after the correct power source is
provided, contact the nearest service center.
Power frequency Error(50/60Hz)
E1
One long beep
for 2 sec
Cause:
Memory IC (EEPROM IC) is not working correctly.
In this case, other features except for memory
function work properly. (You can operate the oven
manually)
Remedy: Press CANCEL pad one or more times and try
to start a memory function program. If the error
code “E5” persists, contact your nearest service
center.
EEPROM Error
E5
One long beep
for 2 sec
If oven does not operate:
● Confirm oven is plugged into dedicated circuit.
● Confirm oven is on grounded and polarized circuit.
(Contact electrician to confirm)
● Check fuse or circuit breaker.
If oven light does not work:
● Confirm light bulb is screwed in tightly.
● Confirm light bulb is not defective.
Warning
To avoid electrical shock which can cause severe personal injury, do not remove
outer case at any time.
Only authorized servicer should remove outer case.
If oven operates intermittently:
● Check inlet and discharge areas for obstructions.
If oven does not accept entries when pad is
pressed:
● Open and close oven door. Press pad again.
If oven malfunctions:
● Unplug oven, wait for 1 minute, and plug in oven.
Before Calling for Service
CM1029B-2 6/14/00 10:24 AM Page 18